Barkbuster Hardware Kit Fat Bars-RRP 494

• To fit tapered (Fat Bar) handlebar.
• Two mounting points secure the full wrap around aluminium design.
• Heat treated aluminium backbone for added strength and impact protection.
• Easy installation.
• Hardware Kit only (NO plastic guards).
• Compatible with  VPS or STORM guards (each sold separately).
• Pt. No. BHG-152-00-NP

NOTE FOR HONDA CB500X OWNERS UP TO 2018:

After extensive trials these are the ONLY handguards that WE have found work in conjunction with the Renthal 609 RC High Fat Bars and our Fat Bar Riser kit for the CB500X, and still clear the screen, in the lower position, at full lock.

For best fitment, it is suggested that the bar clamps are used in the opposite position, the Left clamp on the right bar, the Right clamp on the left bar, and new 9mm holes drilled 20mm away from the original holes in the spine, this gives the best clearance, and puts less strain on the handguards.

If you require the screen in the raised position, we can supply a Spacer Kit to enable this.

NOTE FOR BMW G310GS OWNERS:

After extensive trials these are the ONLY handguards that WE have found work in conjunction with the Renthal 609 RC High Fat Bars (RRP 484/485) and our Fat Bar Riser kit (RRP 825) for the BMW G310GS with either our Sport Screen (RRP 848) or our Adventure Screen (RRP 849) , and still clear the screen at full lock.

THEY WILL HIT THE OEM SCREEN AT FULL LOCK

The very long OEM levers do not fit inside the Barkbuster metalwork. We have found that it is possible to run the levers slightly underneath the metal frame OR trim the last 20mm off the levers, where the slot is, and the file the cut end. This will then allow the levers to fit behind the metalwork, for maximum protection.